# =========================================================
# What:   BusPirate Version 3b with OpenOCD support
# Using:   USB serial on COM port 13
# JTAG:   <available pins & description>   
# See:   http://dangerousprototypes.com/docs/Bus_Pirate_JTAG_connections_for_OpenOCD
# Note:   1) If you have "normal" mode AND "0" pullup,
#         THEN do not connect Vpu & VTref!
#         2) Cygwin uses serial USB COM ports as:
#         /dev/ttyS[N-1] == /dev/comN
#         Make sure it's not already used with
#         any other terminal or programs...
# =========================================================
interface buspirate
# Not yet implemented properly...
#transport select jtag
# Set the serial port to be used:
buspirate_port /dev/buspirate
#buspirate_port /dev/ttyS12
# Set "normal" or "fast" (~1 MHz)communication speed:
buspirate_speed normal
# Turn OFF the voltage regulator:
#buspirate_vreg 0
# ---------------------------------------------------------
# Remember that VTref (Vcc) is connected to pull-up's.
# If you are NOT using pull-up's with "normal" drain
# pin-mode, then do NOT connect Vpu to VTref!
# ---------------------------------------------------------
buspirate_mode normal
buspirate_pullup 0
# ---------------------------------------------------------
#buspirate_mode open-drain   
#buspirate_pullup 1
# ---------------------------------------------------------
# This depends on the cable, you are safe with this option:
reset_config srst_only